Power Generation
Engineering Services

Caesar II stress analysis for high-temperature, high-pressure power plant piping — main steam, hot reheat, cold reheat, feedwater, condensate, and auxiliary steam lines.

• Main steam line stress analysis — sustained, thermal, and occasional load cases
• Hot reheat and cold reheat piping — thermal expansion and flexibility analysis
• Feedwater and condensate system stress analysis
• Equipment nozzle load evaluation — turbine, boiler, feedwater heater nozzle allowables
• Seismic analysis per IBC / IS 1893 for power plant piping
• Spring hanger selection and sizing for high-temperature pipe runs
• Fatigue analysis for systems subject to thermal cycling

PIPENET hydraulic analysis for cooling water systems, condenser water circuits, boiler feedwater systems, and fire water networks.

• Cooling water system hydraulic analysis — cooling tower, condenser, pump sizing
• Boiler feed pump sizing and NPSH analysis
• Condenser circulating water surge analysis — pump trip transient
• Fire water network design and hydraulic calculation for power plant site

Mechanical, Electrical & Plumbing design for power plant auxiliary systems and buildings.

• Electrical system design — HT/LT distribution, load flow, short circuit (ETAP)
• HVAC design for control rooms, switchgear rooms, and battery rooms
• Fire protection for turbine hall, transformer areas, cable galleries (NFPA/NBC)
• Plumbing and drainage for auxiliary buildings

Heat rate improvement and auxiliary power consumption studies for operating power plants.

• Heat rate benchmarking — gross vs. net heat rate, design vs. actual comparison
• Auxiliary power consumption analysis — largest auxiliary power users
• Condenser performance — TTD, DCA, cleanliness factor assessment
• Boiler efficiency analysis — stack losses, radiation, unburnt carbon
• Pump efficiency assessment — cooling water pumps, boiler feed pumps